Rms-technologies R256 CONTROLLER/DRIVER Manuale Utente Scaricare il pdf (Pagina 17)

Changing the Address of the Controller

Use a screwdriver to turn the dial so the arrow points to the desired Address. Use

this number when programming commands. For example, /1P1000R

Figure 14: Address Dial

Note: New RoHS compliant boards have a Black dial instead of a Red one.

Connecting the Accessory Pieces

If you have purchased the Designer’s Kit, there is a Red Push Button and an Optical

Sensor included. Follow the schematics below in order to properly assemble

accessory pieces.

Push Button

Figure 15: Push Button Schematic

It is best to solder the Push Button to Pin 5 which corresponds to Input 4, then

solder Pin 6 (Power Ground) to the other side of the push button.

Input 1 Pin 2

Input 2 Pin 8

RMS Technologies Page 17 Version 1.05

R256 Controller Manual 4/3/2009

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

Nessun commento

Rms-technologies R256 CONTROLLER/DRIVER Manuale Utente Pagina 17